Troubleshooting - Procom PCNSD25TA Owner's Operation And Installation Manual

Vent-free gas stove

Hide thumbs

Table Of Contents

Table of Contents

Use a vacuum cleaner, pressurized air, or a

small, soft bristled brush to clean.

A yellow tip on the pilot flame indicates dust

and dirt in the pilot assembly. There is a small

pilot air inlet hole about 2" from where the

pilot flame comes out of the pilot assembly

(see Figure 31). With the unit off, lightly blow

air through the air inlet hole. You may blow

through a drinking straw if compressed air is

not available.

Air Passageways

Use a vacuum cleaner or pressurized air to

clean.

• If you remove logs for cleaning, refer to Installing Logs, page 15, to properly replace logs.

• Replace log(s) if broken or chipped (dime-size or larger).

WARNING: If you smell gas:

• Shut off gas supply.

• Do not try to light any appliance.

• Do not touch any electrical switch; do not use any phone in your

building.

• Immediately call your gas supplier from a neighbor's phone. Fol-

low the gas supplier's instructions.

• If you cannot reach your gas supplier, call the fire department.

WARNING: Only a qualified service technician should service and

repair heater. Make sure that power is turned off before proceeding.

Turn off and let cool before servicing.

CAUTION: Never use a wire, needle, or similar object to clean

ODS/pilot. This can damage ODS/ pilot unit.

IMPORTANT: Operating heater where impurities in air exist may create odors. Cleaning sup-

plies, paint, paint remover, cigarette smoke, cements and glues, new carpet or textiles, etc.,

create fumes. These fumes may mix with combustion air and create odors.

Note: All troubleshooting items are listed in order of operation.

200199-01B

CARE AND MAINTENANCE

ODS/PILOT

CABINET

LOGS