Setting Up Of Internal Change-Over Switches Receiver - ABB Focus II FII-4-14 Series Original Instructions Manual

4.4 Setting up of Internal Change-Over Switches Receiver

• Disconnect the power supply to the unit and open the small lid in the bottom cap (with the M12 connec-
tor) so that the two change-over switches become visible.
• The change-over switches may be adjusted to the desirable position with a small, suitable screwdriver.
NB! Make sure to always set switches in both banks to the same position (except switch 7 on the
receiver).
Switch Status
OFF
8
ON
OFF
7
ON
OFF
6
ON
4
OFF
1
5 + 4 OFF
ON
ON
Light curtain specific settings:
1
OFF OFF
OFF OFF
OFF ON
3+2+1 OFF ON
ON OFF
ON OFF
ON ON
ON ON
2TLC172015M0201, rev. D
Manual reset
Automatic reset
Refer to Coding section for further information
EDM function disabled
EDM function enabled
5
OFF Muting T with time limit, 0.2 s allowed drop
ON Muting L with time limit, 0.2 s allowed drop
OFF Muting X without time limit
ON Special function with switches 1, 2 and 3
Muting maps when muting T, L or X
are selected on switches 4 and 5
2 3
OFF Muting all beams
ON Muting on module 1, 2, 3 and 4
OFF Muting on module 1, 2 and 3
ON Muting on module 1 and 2
OFF Muting on module 1
ON Muting on module 2
OFF Muting on module 3
ON Muting on module 4
Default setting
1 2 3
OFF
ON
1 2 3
OFF
ON
Switch no. 8 in ON position
Function
Single break if SB/DB selected
Double break if SB/DB selected
Muting and special functions
2
2
6 , 0.2 s allowed drop
3
Blanking ± 1 beam with T muting
Blanking +1/-0 beam with T muting
Blanking ± 0 beam with T muting
Blanking ± 1 beam with L muting
Blanking +1/-0 beam with L muting
Blanking ± 0 beam with L muting
Pre-Reset mode
Single break/double break, Switch 8
18
4 5 6 7
4 5 6 7
2
Special functions selection when
switches 4 and 5 are both ON
www.abb.com/lowvoltage
8
8
4