Operating Instructions; Power Up; Setting The Battery Charging Profile - Dometic Go Power! GP-PWM-30-SB User Manual

7. OPERATING INSTRUCTIONS

7. OPERATING INSTRUCTIONS
7.1 SYSTEM VOLTAGE AND CURRENT
When the GP-PWM-30-SB is connected to the battery, the controller will go into Power Up mode.
Icons Displayed: All segments of the numerical display; backlight blinks. Depending on the battery voltage when the GP-PWM-30-SB Power Up
occurs, the controller may do a Boost Charge or quickly go into Float Charge. The Charging Profile selected will commence the following day after a
Power Up (refer to the Charging Profile Chart on page 11 for more details).

7.2 SETTING THE BATTERY CHARGING PROFILE

3 0 A M P P W M S O L A R C O N T R O L L E R
To select the battery charging profile, press and hold the B Button. This
will cause the current battery type to flash.
Then, press the B Button to toggle through the profile options: Sealed/
Gel, AGM/LiFePO4 or Flooded.
To confirm the battery profile, press and hold the A Button for 3 seconds.
Non-volatile memory: Any settings made on the GP-PWM-10-FM will be
saved even when the power has been disconnected from the controller.
Refer to the Battery Charge Profile Chart below for details on each profile.
gpelectric.com | [page 9]