7. OPERATING INSTRUCTIONS
7. OPERATING INSTRUCTIONS
7.1 SYSTEM VOLTAGE AND CURRENT
When the GP-PWM-10-FM is connected to the battery, the controller will go into Power Up mode.
Icons Displayed: All segments of the numerical display; backlight blinks. Depending on the battery voltage when the GP-PWM-10-FM Power Up
occurs, the controller may do a Boost Charge or quickly go into Float Charge. The Charging Profile selected will commence the following day after a
Power Up (refer to the Charging Profile Chart on page 11 for more details).
7.2 SETTING THE BATTERY CHARGING PROFILE
To select the battery charging profile, press and hold the B Button. This
will cause the current battery type to flash.
Then, press the B Button to toggle through the profile options: Sealed/
Gel, AGM/LiFePO4 or Flooded.
To confirm the battery profile, press and hold the A Button for 3 seconds.
Non-volatile memory: Any settings made on the GP-PWM-10-FM will be
saved even when the power has been disconnected from the controller.
Refer to the Battery Charge Profile Chart below for details on each profile.
7.2 SETTING THE BATTERY CHARGING PROFILE
gpelectric.com | [page 9]