Operating Instructions - Flex XFE 7-12 80 Original Operating Instructions

XFE 7-12 80

Operating instructions

WARNING!
Before carrying out any work on the polis
her, always pull out the mains plug.
Before switching on the power tool
Unpack the polisher and check that there are
no missing or damaged parts.
Switching on and off
Brief operation without engaged switch
rocker
Push the switch rocker forwards and hold

in position.
To switch off the power tool, release the

switch rocker.
Continuous operation with engaged
switch rocker
NOTE
The electric power tool features a starter
interlock. In other words, the electric power
tool will not start running again if still swit
ched on after a power failure.
Switching on electric power tool after a power
failure:
– Switch off the electric power tool.
– Switch on the electric power tool again.
-
Push the switch rocker forwards and

engage by pressing the front end.
To switch off the power tool, release the

switch rocker by pressing the rear end.
Preselecting the speed
-
To set the operating speed, move the dial

to the required value.
CAUTION!
Risk of injury due to destruction of the tool.
Use the appropriate tool for the job.
17