Operating Instructions - Flex XFE 7-12 80 Instruction Manual

XFE 7-12 80

Operating instructions

WARNING
Risk of electric shock! Before carrying out
any work on the power tool, always pull out
the mains plug.
Before switching on the power
tool
Unpack the polisher and check that there
are no missing or damaged parts.
Attaching or changing the tool
holder
– Pull out the mains plug.
– Hold the Velcro plate. Loosen the
hexagon socket head bolt in anti-
clockwise direction using a hexagon
key SW4 and remove the Velcro plate.
– If necessary clean profile spindle.
– Place guide of new Velcro plate on profile
spindle.
– Mount a new Velcro plate on the profile
spindle. To do this, hand-tighten the
hexagon socket head bolt in clockwise
direction.
Attaching or changing
the polishing tool
– Pull out the mains plug.
– Firmly press polishing tool, centred on
the eye, onto the Velcro pad (9).
Use undamaged polishing tools only.
– Insert the mains plug into the socket.
– Switch on the polisher (without engaging
it) and run the polisher for approx.
30 seconds. Check for imbalances
and vibrations.
– Switch off the polisher.
Instruction manual
11