Chicco Baby Control Audio Digital Compact Instructions For Use Manual page 26

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 18
Fault
Cause
- the parent unit (receiver)
The power
/child unit (transmitter)
indicator
is OFF
LED (4)
- The alkaline batteries in
on the
the child unit and/or the
parent unit
rechargeable batteries in
(receiver/
the parent unit are spent.
child unit
- The mains adaptor is
(transmit-
disconnected or connecter
ter) is OFF
incorrectly.
supply
- No sound is received from
the child unit (transmitter);
- The voice activation mode
has been selected
There is
- The volume on the par-
no sound
ent unit (receiver) is set
from the
too low;
parent unit
- The alkaline batteries in
(receiver).
the child unit and/or the
rechargeable batteries in
the parent unit are spent.
- The parent unit (receiver)
could be switched off.
- DECT technology guar-
antees protection against
interference caused by
similar devices, however
on rare occasions they can
be caused by the presence
Interfer-
of another similar device
ence
transmitting in the immedi-
ate vicinity.
- Electromagnetic pollution
(vicinity to transmitting
radio aerials, high voltage
cables etc).
Solution
- Turn the parent unit (receiver) /child unit
(transmitter) ON
- Replace the alkaline batteries in the child
unit and/or the rechargeable batteries in the
parent unit.
- If the units are powered using the mains adap-
tors, check that these are connected correctly to
the mains sockets
- No power
- Check that the socket has power supply.
As soon as any noise/sound is picked up the
transmitter will be activated. In any case, to
make sure it works, asks someone to speak into
the transmitter in the child's room to make sure
you are receiving properly.
- Check the operating mode enabled and the
ON/Off switch which enables the voice acti-
vated mode on the parent unit
- Press the volume button to maximum level
(3) on the parent unit (receiver) until you hear
sounds.
- Replace the alkaline batteries in the child
unit and/or the rechargeable batteries in the
parent unit.
- Turn the parent unit (receiver) ON
- Move the device away from similar devices
and/or move away from this position.
26

Advertisement

Table of Contents
loading

Table of Contents