Initializing Logical Drives - Acer Altos G310 MK2 Series Manual

Initializing logical drives

You can initialize the logical drives using individual initialization,
which initializes a single logical disk.
There are two methods to initialize a logical drive using the individual
initialization procedure using the CU.
For the first method, perform the following steps to initialize a logical
drive using the Initialize menu.
1 On the Management Menu, select Initialize.
2 Use the space bar to highlight the logical drive to initialize.
The logical drive name is highlighted in yellow. To de-select the
logical drive, press the space bar again.
3 Press <F10>.
4 Select Yes at the prompt and press <Enter> to begin the
initialization.
A graph shows the progress of the initialization until it is
complete.
5 After the initialization is complete, press <Esc> to return to
previous menus.
If you press <Esc> while initialization is in progress, the following
options display:
• Stop: The CU stores the percentage of the initialization
already completed. When you restart initialization, it
continues from the last percentage completed rather than
from zero percent.
• Continue: initialization continues normally.
• Abort: The initialization is completely aborted. If you restart
initialization, it begins at zero percent.
For the second method, perform the following steps to initialize a
logical drive using the Objects menu.
1 From the Management Menu, select Objects→ Logical Drive
submenu, as shown in "Logical drive submenu" on page 112.
The configured logical drives display.
111