4.4
Installing Drives
4.4.1 3.5-inch Drive
To install 3.5-inch drives:
1.
Open the front panel of the housing. See section 4.3 for more information on
opening the housing panel.
2.
Detach the 3.5-inch drive frame (2 pieces) from the housing by removing two
screws. Keep the screws for later use.
Do not attempt the procedures described in
the following sections unless you are a
qualified service technician.
Turn off the power switch and unplug the
power cord before installing or removing
diskette drives.
Chapter 4 - System Housing
4-7