Table of Contents
Advertisement
Table 1-4
System Error Messages (continued)
Message
Memory Error at:
MMMM:SSSS:OOO (W:XXXX,
R:YYYY)
where:
M: MB, S: Segment,
O: Offset,
X/Y: write/read pattern
Memory Size Mismatch
Processor Clock Mismatch
Onboard Serial Port 1 Conflict
Onboard Serial Port 2 Conflict
Onboard Parallel Port Conflict
Pointing Device Error
Pointing Device Interface
Error
Press F1 key to continue or
Ctrl-Alt-Esc for Setup
Real Time Clock Error
Press Esc to turn off NMI, any
key to reboot
Real-time Clock Error
Action
Check DIMMs on the system
board. Contact your dealer.
Check the memory size and
processor clock speed installed in
the system. If you are sure that
the values are correct, ignore the
message. If the message
reappears, ask for technical
assistance.
Run Setup (see section 2.1) and
disable the port.
Run Setup (see section 2.1) and
disable the port.
Run Setup (see section 2.1) and
disable the port.
Check and connect pointing
device.
Replace the pointing device or
contact your dealer.
Press
or
+
+
Setup.
Run Setup (see section 2.1) and
set the time and date.
Press
to disregard the NMI
error.
Press any other key to reboot.
Run Setup (see section 2.1).
to enter
Chapter 1 - System Board 1-23
Advertisement
Table of Contents
