Acer Altos 500 Series User Manual page 122

Floppy drive A, 2-6
Floppy drive B, 2-6
Floppy drives, 2-10
Front panel connectors, 1-7
I
IDE drives, 2-12
IDE primary channel master, 2-6, 2-
12
IDE primary channel slave, 2-6, 2-12
IDE secondary channel master, 2-6,
2-12
IDE secondary channel slave, 2-6, 2-
12
Installing a DIMM, 1-17
Installing a Pentium III processor, 1-
13
Installing an expansion board, 4-11
Installing and removing a heatsink,
1-11
Installing components, 1-8
Installing components on the system
board
ESD precautions, 1-9
Instructions, post-installation, 1-10
Instructions, pre-installation, 1-9
Installing drives, 4-7
3.5-inch drive, 4-7
5.25-inch drives, 4-9
Internal cache, 2-5, 2-29
J
Jumper and connector locations, 1-4
Jumper settings, 1-5
Jumpers and connectors, 1-4
Altos 500 Series User's Guide
Connector functions, 1-5
Jumper settings, 1-5
Locations, 1-4
L
Load default settings, 2-41
LS-120 drive compatible as, 2-11
M
Main board ID, 2-8
Main board S/N, 2-9
Major components, 1-2
System board layout, 1-3
Memory configurations, 1-16
Memory test, 2-25
Memory upgrade, 1-16
Configurations, 1-16
DIMM, installing, 1-17
DIMM, removing, 1-18
Reconfiguring the system, 1-19
Memory/cache options, 2-29
N
Num lock after boot, 2-25
O
Onboard device settings, 2-19
Onboard peripherals, 2-16
Onboard device settings, 2-19
Parallel port, 2-7, 2-17
Serial ports 1 and 2, 2-16
Opening the housing panels, 4-5
Front panel, 4-2, 4-5