Boot Device Options Screen - Acer Altos 500 Series User Manual

Boot Device Options
This option shows the target ID of the device you are booting from. The default
setting is 0 (zero).
operating systems will not run unless the boot device is set at zero.
The figure below shows the Boot Device Options screen.
Adaptec AHA-3950U2B
Configuration
SCSI Bus Interface Definitions
Additional Options
Select SCSI peripherals from which to boot
To view peripherals by ID# select "SCSI Disk Utilities" from previous menu
Boot Channel...............................................................................
Boot SCSI........................................................................0
-----------Options Listed Below Have NO EFFECT if Multiple Lun Support is Disabled------------
Boot Lun Number ........................................................................ 0
Arrow keys to move cursor, <Enter> to select option, <Esc> to exit (
Figure 3-7 Boot Device Options Screen
Altos 500 Series User's Guide
We recommend that you not change this setting.
AHA-3950U2B at Bus:Device 00:00h
Host Adapter SCSI ID................................ 7
SCSI Parity Checking ................................ Enabled
Host Adapter SCSI Termination................. Low ON/High ON
Boot Device Configuration
Boot Device Options .................................. Press <Enter>
SCSI Device Configuration ........................ Press <Enter>
Advanced Configuration Options ............... Press <Enter>
<F6> - Reset to Host Adapter Defaults
SCSISelect (TM)
Some
Utility
A First
=default)
*