Information Importante - Breckwell Classic Cast SPC4000 Owner's Manual

Hide thumbs Also See for Classic Cast SPC4000:

Owner's manual (29 pages)

Manual (48 pages)

Table Of Contents

Table of Contents

This manual describes the installation and operation of the Breckwell, SPC4000 wood heater. This heater

meets the 2015 U.S. Environmental Protection Agency's crib wood emission limits for wood heaters sold after

May 15, 2015. Under speciﬁ c test conditions this heater has been shown to deliver heat at rates ranging from

6,569 to 34,785 Btu/hr.

Thank you for purchasing your pellet burning stove, you are now prepared to burn wood in the most efﬁ cient,

convenient way possible. To achieve the safest, most efﬁ cient and most enjoyable performance from your

stove, you must do three things: 1) Install it properly; 2) Operate it correctly; and 3) Maintain it regularly. The

purpose of this manual is to help you do all three.

PLEASE read this entire manual before installation and use of this pellet fuel-burning room heater. Fail-

ure to follow these instructions could result in property damage, bodily injury or even death.

Keep this manual handy for future reference.

This stove has been independently tested to ASTM E1509-12 Standard Speciﬁ cation for Room Heaters, Pellet

Fuel Burning Type 1, ULC-S627 Standard for Solid Fuel Room Heaters, and Oregon Administrative Rules for

Mobile Homes (814-23-900 through 814-23-909) and Installation as a Stove Heater.

This pellet stove, when installed, must be electrically grounded in accordance with local codes, or in the ab-

sence of local codes, with the National Electrical Code, ANSI/NFPA 70.

The authority having jurisdiction (such as municipal building department, ﬁ re department, ﬁ re preven-

tion bureau, etc.) should be consulted before installation to determine the need to obtain a permit.

This appliance is designed speciﬁ cally for use only with pelletized wood. It is designed for residential installa-

tion according to current national and local building codes as a freestanding room heater. It is also approved as

a mobile home heater which is designed for connection to an outside combustion air source.

The stove will not operate using natural draft or without a power source for the blower systems and fuel feed

system and must not be burned with any type of coal (see PROPER FUEL).

This stove is designed to provide the optimum proportions of fuel and air to the ﬁ re in order to burn free of

smoke and soot. Any blockage of the air supply to or from the stove will seriously degrade its performance and

will be evidenced by a smoking exhaust and a sooting window. For best operation the ash content of the pellet

fuel should be less than 1% and the caloriﬁ c value approximately 8200 BTU/LB. Avoid high ash content fuels

because this will rapidly ﬁ ll up the burn pot and eventually cut off the combustion air supply.

Commercial and industrial installations of this pellet toves should not be used since operational control is often

not well managed in these settings.