Table of Contents
Advertisement
STEP 2: INSTALL UPPER RAIL AND SIDE BRACKETS
1. Affix foam gasket to bottom of upper rail bracket (if not
already affixed).
2. Install upper rail and side retainers to cabinet as
shown using a total of 10 5/16" screws, with the
screws being inserted from the inside of the cabinet.
STEP 3: ASSEMBLE WINDOW FILLER PANELS
1. Place the cabinet on a steady surface such as a floor,
bench or table.
2. Slide I section of window filler panel into side retainer on
the side of the cabinet. Do this for both sides (Figs. J, K).
Plastic
Frame
Fig. J
3. Slide the filler panel's horizontal top and bottom rails into the channels on both the
bottom of the cabinet and the upper angle bracket.
4. Insert washer head locking 7/16" screws( H). Do not overly tighten – allow the rails
to move freely. You will tighten them during step 6.
STEP 4: PLACE CABINET IN WINDOW
1. Open window and mark center of window stool as shown in Fig. L.
2. Place cabinet in window with the bottom stool angle seated over the window stool
as shown. Bring window down temporarily behind upper rail to hold cabinet in
place (Fig. M).
Fig. L
Window Filler
Panel
Side Retainer
Air Conditioner
Cabinet
Top
View
Stool
–18–
Fig. I
Plastic
Frame
Locking
"I" Section
Screw Hole
Window
Fig. K
Filler Panel
Stool
Angle
Fig. M
Advertisement
Table of Contents
