Impecca IWA15-KS30 User Manual page 17

bottom left side and repeat on the right side. Gently dislodge, noting that the con-
trol panel will be connected to the main unit (Figures C, D).
5. Disconnect the connector plug of the control panel and place the front panel to one
side, with the control panel still attached (Fig. E)
Fig. C
6. Remove the shipping screws from the top of the cabinet and any that may be in-
stalled on the side of the base (Fig. F).
7. The shipping screws are not needed for the rest of this installation procedure. Cover
over the holes on the top of the cabinet with the two included foam inserts (Fig. G).
shipping
screws
Fig. F
8. Your unit may have shipped
with internal packaging that
protected the compressor
from damage during shipping
(Fig. H). If so, now is the time
to remove this packaging by
cutting the plastic tie.
Fig. E
Shipping Packaging
Plastic tie
–17–
Fig. D
Fig. G
Fig. H