Choosing A Location To Mount Unit - Kelvinator KSV25CRH Installation Manual

Choosing a location to mount unit

Indoor unit
• Do not install the unit near any heat source, ammable gas or
steam.
• Choose a location where the air circulation is good, and where
there are no obsticles blocking the air ow.
• Select a place that will be convenient to run a drain to suitable
location outside.
• A place where noise prevention is taken into consideration.
• Do not install the unit near the door way.
• Ensure the restrictions on installation sp
unit installation drawings are met.
• Select a location which is
the device is not subjected to vibrations.
• The device should be installed at a distance of at least 1m
from all other electrical devices and installations, e.g. TV,
radio,computer, etc.
• Avoid installing in direct sunlight, if it's unavoidable consider
installing something to protect from direct sunlight.
reas
Your air conditioner is designed to condition the air for a certain
range of room size, please ensure the selection of your air
conditioner complies with the Kelvinator selection tool available
from www.kelvinator.com.au
This product uses mildly ammable R32 refrigerant. Certain levels
of refrigerant require minimum room sizes. Please ensure that these
minimum room sizes are adhered to for standard installations (up
to 5m pipe length). If larger refrigerant charges than standard are
used then please consult AS/NZS 60335.2.40 to determine the safe
minimu oor area for the installation.
Model Charge of R32 (g)
KSV25CRH
KSV25HRH
KSD25HRH
830
KSV25HWH
KSD25HWH
KSV35CRH
KSV35HRH
KSD35HRH
900
KSV35HWH
KSD35HWH
KSV50HRH
KSD50HRH
1450
KSV50HWH
KSD50HWH
KSV71CRH
KSV71HRH
KSD71HRH 1600
KSV71HWH
KSD71HWH
KSV90HRH
KSD90HRH
2700
KSV90HWH
KSD90HWH
4 Choosing a location Kelvinator Air Conditioning
ed in the indoor
enough for installation so that
Minimum r area (m
N/A
N/A
2.00
2.44
6.95
Outdoor unit
• If an awning is built over the unit to prevent direct sunlight or
rain, be careful that heat radiation from the condenser is not
obstructed.
• Do not install outdoor unit in a location where the air outlet will
be directed on plants or animals as it may harm them.
• Make sure that there is suf
installation drawings.
• Do not place any obstacles which may cause an obstruction
of the discharge air.
• Select a location which avoids causing a nuisance to
neighbours from noise and air emissions from device.
• Select a location which is suf
• Never cover the air inlets and outlets.
• The location must be suf
prevention of vibrations.
• There must be no risk presented by combustible gas or gas
escaping as a result of corrosion.
• Avoid a location where there is a high salt content.
• Avoid a location which is heavily exposed to dust.
• Avoid a location to which the general public have access.
)
2
nt space as spe ed in the
ntly well ventilated.
e r installation and the