System Menu - ADJ VIZI BEAM 5RX User Manual

Vizi Beam 5RX
System Menu: When making adjustments press ENTER to confirm your setup then press and
hold the MENU button for at least 3 seconds. To exit without making any adjustments press
the MENU button. The display will lock after 30 seconds. Press the MENU button for 3 sec-
onds to unlock.
ADDR - DMX Address Setting.
1. Press the either the MENU, UP, or DOWN buttons until "ADDR" is displayed, then press ENTER.
2. The current address will now be displayed and flashing. Press the UP or DOWN buttons to find
your desired address. Press ENTER to set your desired DMX address.
CHND - This will let select your desired DMX channel mode.
1. Press the MENU button until "CHND" is displayed, and press ENTER. Either "16CH" or "19CH"
will be displayed.
2. Press the UP or DOWN buttons to find your desired DMX channel mode and press ENTER to
confim and exit.
IPAN - Pan Inversion.
1. Press the MENU button until "IPAN" is displayed, and press ENTER. Either "Yes" or "No" will be
displayed.
2. To activate the Pan inversion press the UP or DOWN buttons until "Yes" is displayed, then press
ENTER to confim. To deactivate Pan inversion, select "No" and press Enter.
ITLT - Tilt Inversion.
1. Press the MENU button until "ITLT" is displayed, and press ENTER. Either "Yes" or "No" will be
displayed.
2. To activate the tilt inversion press the UP or DOWN buttons until "Yes" is displayed, then press
ENTER to confim. To deactivate tilt inversion, select "No" and press Enter.
LED - The backlighting for the display can be set to turn off after 10 seconds.
1. Press the MENU button until "LED" is displayed, and press ENTER.
2. The display will show either "ON" or "OFF". Press the UP or DOWN buttons to select "ON" to
keep the LED display on at all times, or "OFF" to switch to have the LED display switch off after
10 seconds.
3. Press ENTER to confirm. To make you LED display reappear again press any button.
DISP - This function will reverse the display 180º.
1. Press the MENU button until "DISP" is displayed, and press ENTER.
2. Press UP or DOWN to toggle between "OFF" and "ON."
3. Press ENTER when you have made your desired setup.
TEST - This function will run a self test program.
1. Press the MENU button until "TEST" is displayed, and press ENTER.
2. The fixture will now run a self test.
ADJ Products, LLC - www.adj.com - Vizi Beam 5RX User Manual Page 15

System Menu