Inserting/Removing The Memory Card; Formatting The Memory Card - Panasonic AJ-UPX360ED Operating Instructions Manual

Inserting/removing the memory card

Inserting the memory card
The memory card to use with the camera should always be formatted on the camera. (page 43)
f Formatting the memory card will erase all of the recorded data which cannot be restored.
Card 2 access lamp
1
Open the card slot cover.
2
Insert the memory card into the card slot.
f Card slot 1 and card slot 2 can each insert one memory card.
f Insert straight in with the label facing left until it clicks.
Do not force or apply excess force when inserting the memory card.
3
Close the card slot cover.
Removing the memory card
1
Open the card slot cover.
f Confirm that the card access lamp is not flashing in orange.
f Data is being written/loaded when the card access lamp is flashing in orange, so do not remove the memory card.
2
Press in the memory card further into the camera and let go.
f Pull the memory card straight out when it is released from from the card slot.
3
Close the card slot cover.
Cautions when using or storing
f Do not touch the connecting terminal section at the rear of the memory card.
f Avoid high temperature and humidity.
f Avoid water droplets.
f Avoid charging with electricity.
Use or store the memory card with the card inserted into the camera and with the slot cover closed.

Formatting the memory card

1
Select the [RECORDING] menu → [FORMAT MEDIA] → [SLOT1]/[SLOT2].
2
When the confirmation message is displayed, select [SET].
3
When the completion message is displayed, select
@
NOTE
t This function can be operated also by touching the LCD monitor.
t It may take few seconds after closing the completion message until it can record.
Chapter 3 Preparation — Preparing the memory card
Card slot 1 Card 1 access lamp
Card slot 2
.
– 43 –
Card slot cover