What You Can Do With This Camera; Recording To The Memory Card; Linking To External Devices - Panasonic AJ-UPX360ED Operating Instructions Manual

What you can do with this camera

This camera is an industrial 4K hand-held camera recorder equipped with a 1.0-inch sensor.
f Equipped with a high-sensitivity 1.0-inch MOS sensor for approximately 15.03 million effective pixels.
Achieves F12 (at 59.94 Hz)/F13 (at 50 Hz) in the high-sensitivity mode.
f The UHD (3840×2160) 59.94p/50p signal can be recorded to the memory card with high image quality and high efficiency 10 quantizing bits.
f Equipped with wide angle 24.5 mm (35 mm conversion value), approximately 32x zoom using the I.ZOOM function (approximately 24x zoom when
recording in UHD), and hybrid optical image stabilizer (Hybrid O.I.S.).
f Equipped with a LAN terminal that supports live streaming and wired control (Gigabit Ethernet), in addition to the input/output terminals (XLR input/SDI
output) which are necessary for business use.

Recording to the memory card

Recording in following types is possible.
f P2 recording (P2 MXF compatible)
f UHD and FHD recording
(4:2:0 (10-bit) MOV recording (HEVC)/4:2:0 (8-bit) MOV recording/4:2:2 (10-bit) MOV recording)
f AVCHD recording
f Variable frame rate recording
(Supports 120fps/100fps shooting at the FHD resolution)
f Simultaneous recording
f Relay recording
f Interval recording
f Background recording
f Pre-recording
f 4ch audio recording

Linking to external devices

Connecting to monitor
A monitor can be connected to output images.
* Use a commercial video/audio cable (4-pole mini plug).
Check the wire specifications of the 4-pole mini plug.
f Use the double shielded cable supporting 4K/60P as the HDMI cable (optional). It is also recommended to use the Panasonic 4K/60P compatible
HDMI cable.
f For the BNC cable (optional) connected to the <SDI OUT> terminal, prepare a double-shielded cable equivalent to 5C-FB.
Chapter 1 Overview — What you can do with this camera
Video/audio cable (<AV OUT> terminal)
*
HDMI cable
BNC cable (<SDI OUT> terminal)
Audio (Left audio: White)
Video (Yellow)
Ground
– 18 –
Audio (Right audio: Red)
Monitor