Advertisement
9. NAT
► NAT Settings
1 Make sure the DVR is powered and connected to a network.
2 Go to Start → Settings → Network → TCP/IPv4. You can obtain the
IP address, subnet mask and gateway automatically. You can also
manually enter them according to the actual network situation.
Please make sure the network segment is the same as that of the
network which is used.
3 Set the preferred or alternative DNS Server. Click "Apply" to save
the parameters.
4 Go to Start → Settings → Network → NAT tab. Enable NAT and
select the NAT Server (The default NAT Server is nat.auto-
nat.com). Click "Apply" to save the parameters.
► NAT Access
After finishing the NAT settings, you can input www.autonat.com in
the IE address bar and then press enter to go to the following inter-
face. If this is the first time accessing the NAT, you need to download
and install the Plug-in according to the popup tips. After installing the
Plug-in successfully, it will display the login box.
Device Serial Number: Click
live interface to check the serial number or go to Start → Settings →
Network → Network Status to check the serial number of the DVR).
Username: The username of the DVR. (Default: admin)
Password: The password of the DVR. (Default: 123456)
10. Playback
►Instant playback
Click "Instant Playback" in the right-click menu of the camera's
preview window to select.
►General playback
Click
on the tool bar at the bottom of the live preview inter-
face or click Start → Playback to go to the playback interface
as shown. You can also add the playback cameras manually.
Click
in the playback window to pop up the "Add Camera"
window. Check the cameras in the window and then click "Add"
to add playback camera. The recorded files of the added
playback camera will be played in the playback interface.
on the menu bar at the bottom of the
TCP/ IPv4
Port
DDNS
E-mail
UPnP
NAT
Enable
NAT Server
nat.autonat.com
Enter device serial number
Enter Username
Enter Password
Login
NAT
Network Status
Apply
Advertisement
