Taylor C820 Original Operating Instructions page 9

DO NOT use cold water or ice to cool the
upper platen or the lower cook surface. Failure to
follow this instruction may result in:
S
serious electrical shock
S
burns from hot steam
S
liquid collecting inside the grill and
destroying electrical components
Failure to follow the instructions below may
result in severe burns from high temperatures:
S
DO NOT prepare or remove product without
proper equipment.
S
DO NOT allow untrained personnel to
operate this grill.
S
USE EXTREME CAUTION when cleaning
the grill.
Appropriate grill clearance must be
maintained from all combustible materials. Failure to
comply could result in a fire hazard.
Take caution to protect eyes, lungs, and all
parts of the body from potential harm when using
any chemical cleaner. Failure to follow this
instruction may result in a chemical burn.
DO NOT use any abrasives or cleaners
other than approved foodservice cleaners and
degreasers. Failure to comply may cause illness to
the consumer and may also damage grill surfaces.
This grill must be installed on a level
surface. Failure to comply may result in personal
injury or equipment damage.
Model C820 & C822
The grill must be pulled away from the wall
for thorough cleaning. Disconnect the tether to the
grill, located on the back panel of the unit. When
returning the grill to its original position, use extreme
caution to smoothly and slowly roll the grill backward
into place. Failure to do so may cause the grill to tip
and will cause severe equipment damage or
personal injury.
NOTICE all warning labels that have been
attached to the grill to further point out safety
precautions to the operator.
This piece of equipment is made in America and has
American sizes on hardware. All metric conversions
are approximate and vary in size.
NOISE LEVEL: Airborne noise emission does not
exceed 70 dB(A) when measured at a distance of
1.0 meter from the surface of the machine and at a
height of 1.6 meters from the floor.
These instructions are valid only if the country code
symbol appears on the appliance. If the symbol does
not appear on the appliance, refer to the technical
instructions which give the necessary instructions for
adapting the appliance to the utilization conditions of
that country.
If the crossed out wheeled bin symbol is
affixed to this product, it signifies that this product is
compliant with the EU Directive as well as other
similar legislation in effect after August 13, 2005.
Therefore, it must be collected separately after its
use is completed and cannot be disposed as
unsorted municipal waste.
The user is responsible for returning the product to
the appropriate collection facility, as specified by
your local code.
For additional information regarding applicable local
laws, please contact the municipal facility and/or
local distributor.
5
Safety