Taylor C820 Original Operating Instructions page 15

Step 3
Hold the non-hemmed end of the release material
sheet. Gently pull the sheet tight, wrapping it around
the platen in a side-to-side manner.
Figure 7
Note: Check the alignment of the release material
and make sure it fits smoothly over the upper platen.
Step 4
Place the release material clips over the release
material sheet. Press them into place over the
release material bar at the top of the platen.
Figure 8
Model C820 & C822
Step 5
Check the tightness of the release material against
the upper platen.
Note: Installing the release material sheets too
tightly may cause premature failure of the sheet.
Step 6
Repeat steps 1 through 5 for the other upper
platen.
Note: Temperature checks should only be
conducted with the release material sheets
removed.
The release material must be replaced when:
S
Cleaning procedures fail to remove all
buildup and product sticks to the release
material.
S
A tear appears in the cooking area of the
release material, causing product to stick to
the release material.
11
Figure 9
Figure 10
110602
Operating Procedures