Taylor C820 Original Operating Instructions page 16

Note: It is not necessary to change the release
material if small pin holes develop on the sheet.
CAUTION: The upper platen surface and
release material are very hot. To prevent burn
injuries, wear heat-resistant gloves when
replacing release material.
Care of Release Material Sheets
DO NOT:
S
DO NOT fold or crease.
Figure 11
S
DO NOT touch with sharp objects, grill
scrapers, or abrasive pads.
S
DO NOT place under other equipment or
objects.
S
DO NOT hot-hose or soak in water.
DO:
S
DO clean with a squeegee after each run of
product.
S
DO wipe with a clean, sanitizer-soaked grill
cloth a minimum of 4 times per hour and
more often during peak periods.
S
DO clean daily on both sides, using an
approved high temperature grill cleaner and
the grill cleaning pad and holder identified
on page 8.
110602
Operating Procedures
IMPORTANT! Clean the release
sheets using the grill cleaning pad and
holder identified on page 8 ONLY. Using any
other pad and holder will damage the
release sheets.
Note: Contact your local Taylor Distributor to
purchase the grill cleaning pad and holder.
(See page 8.)
S
DO rinse to remove cleaner and allow to dry
on a flat surface.
S
DO rotate the release material daily and
re-install on opposite side than previously
used (black side vs. brown side).
Start Up of the Grill
IMPORTANT! The lower grill surface and the
upper platen MUST BE CLEAN before starting
these procedures.
Step 1
Place the power switch in the ON position.
12
Figure 12
Figure 13
Model C820 & C822