Yamaha YZF-R1 2020 Service Manual page 237

b a
8. Install:
• Handlebar grip "1"
• Grip end (left) "2"
Grip end bolt
3.8 N·m (0.38 kgf·m, 2.8 lb·ft)
a. Apply a thin coat of rubber adhesive onto
the end of the left handlebar.
b. Side the handlebar grip over the end of the
left handlebar.
c. Wipe off any excess rubber adhesive with
a clean rag.
EWA13700
WARNING
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
TIP
There should be 1–3 mm (0.04–0.12 in) of clear-
ance "a" between the handlebar grip and the grip
end.
a
1
G088918
9. Adjust:
• Clutch lever free play
Refer to "ADJUSTING THE CLUTCH LEVER
FREE PLAY" on page 3-13.
Clutch lever free play
10.0–15.0 mm (0.39–0.59 in)
4-88
HANDLEBARS