Table of Contents
Advertisement
3.
If the button is not pressed and there is no clicking, then you
should wait until the thermal switch cools down to the initial
temperature.
WARNING!
Non-professionals are not allowed to disassemble the thermal
switch to do reset. Please contact professionals of MODENA to
maintain this water heater. Otherwise, MODENA will not take
responsibility of any accidents.
Problem
Heating indicator light
is off.
No water coming out
from the hot water
outlet.
Water Temperature is
over-high.
Water leak.
Manual Reset Button
Manual Reset Button
PART 6: TROUBLESHOOTING
Possible Cause
Failure of the temperature
controller.
1. The inlet water is cut off.
2. The water pressure is too
low.
3. The inlet water valve is not
open.
Failure of the temperature
control system.
Problem on the seal of each
pipe joints (connection).
Contact MODENA Customer
Care for repair.
1.
2. Use the water heater
3. Open the water inlet
Contact MODENA Customer
Care for repair
Seal up the joints.
11
Recommended Actions
Wait for the water
supply to be restored.
again when the water
pressure is increased.
valve
of
running
water supply.
Advertisement
Table of Contents
Need help?
Do you have a question about the Sano Series and is the answer not in the manual?
Questions and answers