Prepare The Appliance - Valor G3 Installation Manual

General Notes Regarding Conversion
The conversion may be done before or after the
appliance is installed into the cavity. However, the gas
must be connected to set the manifold pressure.

Prepare the Appliance

1. If the fi replace is already installed, remove the front
trim, the window, fuel bed. Be careful with fuel bed
as components are fragile.
2. Remove the fuel bed support (2 screws).
3. Remove the burner cover (2 screws).
4. Carefully remove the liner panels.
5. Remove the burner cover support (3 screws).
6. Using two wrenches, disconnect gas inlet from the
control valve.
7. Remove the burner plate (12 screws). It is necessary
to access the by-pass screw on underside of valve.
If the appliance has been burned previously, it may
2
be necessary to pry the burner module gaskets as
they tend to adhere when removed the fi rst time.
Replace Burner Injector
1. Undo burner supports (4 screws).
2. Unscrew the nut at the end of the burner fuel
supply line, and lift the burner and supports out of
the fi replace (complete with injector elbow at-
tached).
Injector elbow
Nut
3. Unscrew and disengage the injector elbow. Be
aware that four pieces sit between the elbow and
the burner, do not drop them.
4. Exchange injector elbow from kit, verifying the new
injector before you install—see Specifi cations table
on page 1. The injector number is stamped on the
corner of the elbow.
5. Exchange the air shutter from kit as its shape is dif-
ferent for each fuel.
6. Reassemble the burner, putting the fl at washer, ten-
sion washer, air shutter, and anti-fl ashback shield
back in order as shown below. Reconnect injector
Tension washer
Natural
different shape
Flat washer
(wavy)
Air shutter
for each fuel
Anti-flashback
shield
Propane