Table of Contents
Advertisement
4. Basic Operations
This chapter describes basic NAS operations.
Power Button
Operation
Power on
Power off
Force power off
Reset Button
Operation
Basic system reset
Advanced system
reset
LEDs
LEDs indicate system status and related information when the NAS is powered on. The following LED
information applies only when the drive is correctly installed and when the NAS is connected to the network.
For details on the location of the LEDs, see Components.
Press the button once.
Press and hold the button for 1.5
seconds.
Press and hold the button for 5
seconds.
User Action
Press and hold the
button for 3 seconds.
Press and hold the
button for 15 seconds.
User Action
The following settings are reset to default:
• System administrator password: admin
• TCP/IP configuration:
• Obtain IP address settings automatically via
DHCP
• Disable jumbo frames
• If port trunking is enabled (multi-LAN models
only), the port trunking mode is reset to "Active
Backup (Failover)".
• System port: 8080 (system service port)
• Security level: Low (Allow all connections)
• LCD panel password: (blank)
• VLAN: Disabled
The default factory settings are restored.
• To retrieve old data after an advanced system reset,
recreate the previous folder structure on the NAS.
HS-453DX User Guide
Result
The NAS powers on.
The NAS powers off.
The NAS shuts down.
Important
Use this method only
when the NAS is
unresponsive.
Result
Basic Operations
43
Advertisement
Table of Contents
