Table of Contents
Advertisement
4. Basic Operations
This chapter describes basic NAS operations.
Audio alerts
Duration
Short beep (0.5 seconds)
Long beep (1.5 seconds)
Long and short beeps
LEDs
LEDs indicate the system status and related information when the device is powered on. The following
LED information applies only when the drive is correctly installed and when the device is connected to the
network or to a host.
For details on the location of the LEDs, see Components.
Frequency
1
3
3 (every 5 minutes)
2
1
1 long and 2 short beeps
Description
• The NAS is starting up.
• When the reset button is pressed for 3 seconds,
the NAS resets configurations.
• When the reset button is pressed for 10 seconds,
the NAS resets configurations and reboots.
• The NAS data cannot be copied to the external
storage device connected to the USB One Touch
Copy port.
• The operating system was updated.
• A power error occurred.
• A system fan is not functioning.
• A fan module has been removed.
• A storage pool is about to reach full capacity.
• A storage pool has reached full capacity.
• A storage pool status error occurred.
• A shared folder is about to reach its full capacity.
• A shared folder has reached its full capacity.
• A shared folder status error occurred.
• A drive is plugged in or out.
• The NAS is powering off.
• The NAS was powered on successfully and is
ready.
The JBOD expansion unit has been removed.
TS-hx77AXU-RP User Guide
Basic Operations
44
Advertisement
Table of Contents
