Installing Qts Using Qfinder Pro - QNAP HS-453DX User Manual

Method
Local installation If the NAS supports HDMI output, you can do the
following:
For details, see
Connection.

Installing QTS Using Qfinder Pro

Warning
Installing QTS deletes all data on the drives. Back up your data before proceeding.
1. Power on the NAS.
2. Connect the NAS to your local area network.
3. Run Qfinder Pro on a computer that is connected to the same local area network.
Note
To download Qfinder Pro, go to https://www.qnap.com/utilities.
4. Locate the NAS in the list and then double-click the name or IP address.
The Smart Installation Guide opens in the default web browser.
5. Click Start Smart Installation Guide.
6. Specify the following information.
• NAS name: Specify a name with 1 to 14 characters. The name supports letters (A to Z, a to z),
numbers (0 to 9), and hyphens (-), but cannot end with a hyphen.
• Password: Specify an administrator password with 1 to 64 characters. The password supports all
ASCII characters.
7. Click Next.
8. Specify the time zone, date, and time.
Tip
QNAP recommends connecting to an NTP server to ensure that the NAS follows the
Coordinated Universal Time (UTC) standard.
9. Click Next.
10. Select Obtain an IP address automatically (DHCP).
11. Click Next.
12. Select the types of devices that you will use to access shared folders on the NAS.
13. Click Next.
14. Select Configure disks later.
Description
• Connect the NAS to the required hardware.
• Complete the steps in the Smart Installation
Guide wizard.
Installing QTS Using an HDMI
HS-453DX User Guide
Requirements
• Monitor
• HDMI cable
• USB keyboard or Remote
control (not available on all
models)
Installation and Configuration 39