Table of Contents
Advertisement
GD8200 User Guide
Modem does not establish a connection
You may have incorrect parameters selected for your application
„
to talk with the remote modem. Refer to the online help for your
application.
You may need to adjust your modem's baud rate or protocol
„
selection.
PC Cards
I can't remove the PC card
Press the ejector button located inside the PC card door on the
„
side of the computer. The button will pop out. Press the ejector
button again to eject the PC card. Slide the card out.
If the ejector button malfunctions when you press it, release the
„
button and then press it again.
Read Error
If a memory card that is not properly formatted is installed in
the PC Card slot, it will cause this error.
Computer locks when the PC card is removed
Before you remove the card, select the PC card icon (
on the taskbar (in the tray area near the clock in the lower right
corner) and choose "Stop [card name] card."
Miscellaneous Troubleshooting
Computer shuts off unexpectedly
The computer has entered suspend mode. Press any key to
„
resume from the standby state. Press the
resume from the hibernate state.
The battery capacity may be low. Connect external power to
„
charge the battery, or replace the battery with a fully charged one.
Speaker volume is too high or too low
Refer to the
audio section
Computer won't turn on
Make sure a fully charged battery is properly installed.
„
Connect external power to charge the battery if it is not charged.
„
If you are using the AC adapter check the electrical outlet you are
„
using to make sure it is working properly.
If the computer does not turn on, reset the computer by holding
„
POWER BUTTON
down the
POWER BUTTON
then press the
General Dynamics Itronix 72-0146-001
POWER BUTTON
for instructions on adjusting volume.
for at least ten seconds, release it,
again.
Computer won't turn off
For Windows
7:
®
1.
Select
Start
and click on the arrow next to the
menu. Then select
2.
If that does not work, press
Task Manager
3.
If any programs are open, use your arrow keys to highlight
each one and select
are closed.
4.
If that still does not work, press and hold the
approximately ten seconds and then release it.
Computer enters suspend mode too quickly
For Windows
7:
®
Select Start, Control Panel, System and Security. Under
Power Options select Change when the computer sleeps.
Modify the Put the computer to sleep option.
Computer doesn't automatically suspend
Exit any application that uses COM ports.
„
or
)
Make sure external power is not connected. Depending on
„
power settings, some systems will not suspend automatically
when they are connected to external power.
System date and time are incorrect
Windows
7
®
Select Start, Control Panel. Then select Clock, Language and
Region. Under Date and Time, make the appropriate changes.
to
"Out of memory" error message
Restart the computer.
„
Too many applications may be running at the same time. Close
„
applications you don't need.
Make sure you have enough space on your hard disk (at least
„
15% free).
Holding down the Power button to reset the com-
puter doesn't always work
Try resetting the computer again. If this doesn't work, remove all
„
power, including the battery pack, and allow the unit to remain
idle for ten minutes. After ten minutes, connect external power
and retry.
The LEDs, backlight, and/or keyboard backlight don't illuminate.
„
You may have enabled
„
Disable Stealth mode.
Troubleshooting
Restart
to reboot the computer.
CTRL+ALT+DEL
.
End Task
. Repeat this until all programs
Stealth mode
in the
Shut down
and then select
Power Button
for
Bios Setup Utility
.
Advertisement
Table of Contents
