Table of Contents
Advertisement
USING CONNECTION MANAGER
If using a USB device, you can connect the device to the carrier's network with Connection Manager. Refer to
Connecting a
Device.
If using a serial device, you need to set up the device in Windows Device Manager before connecting the device.
Refer to
Setting Up a Serial Device in Windows Device
Setting Up a Serial Device in Windows Device Manager
To set up the device in Windows Device Manager:
1.
Make sure that your desired COM port for the serial device is available.
2.
Connect the serial device to the PC.
3.
Go to Control Panel > Device Manager. Make a note of the COM port number for the connected device
(in COM Ports).
Example: The COM port is COM31.
4.
Go to Action > Add legacy hardware.
5.
In the Add Hardware Wizard:
a.
Click Next.
b.
Select Install the hardware that I manually select from a list, then click Next.
c.
Select Modems, then click Next.
40
To open Connection Manager after installation, check Start the MultiTech Connection
Manager when the installation is finished.
After the drivers are installed, you need to restart your computer if prompted by Windows.
Manager.
SocketModem
®
Cell MTSMC-L4G1 Device Guide
Advertisement
Table of Contents
