Table of Contents
Advertisement
Overview
KP-F520WCL are CameraLink output type black and white camera which utilized the 2/3 –inch progressive scan CCD
image sensor with square pixel.
It provides images at 18 frames per second with non-interlaced output.
Since square pixel CCD is adopted, the image that is appropriate for the picture processing is obtained.
Standard composition
Check when unpacking
Camera ········································································································· 1
Warranty card ···························································································· 1
Optional accessories
(1) 12 pin plug
(2) Junction box
(3) Dummy glass (AR coated) ARC1214
(4) IR cut filter
(5) Tripod adaptor
(6) Mini-CameraLink cable
Features
・High resolution
The 2/3-inch 5,000,000 pixels square lattices CCD achieve a high resolution.
・Small and lightweight
The small SDR connector for digital output allows the camera size and mass to be drastically reduced to 29(W) x 29(H) x 29(D)
mm / approx. 55g.
・Automatic power supply source change
The power supply through the cameralink cable is possible from the PoCL frame grabber board. The power supply from the
DCIN/SYNC connector is also possible, so it can be work with an usual frame grabber board.
The power supply from the DCIN/SYNC connector is given to priority when the power supply is supplied from both.
System example
KP-F520WCL connects to the frame grabber board by using CameraLink cable.
HR10A-10P-12S(01)
JU-F30/JC-100
IRC650
TA-UBGV
Power over type
Mini-CameraLink cable
Mini-CameraLink cable
AC adaptor
(7) Camera cable (12pin cable)
Molded type
2m
C-201KSM
5m
C-501KSM
10m
C-102KSM
In the CE Marking region, use the shied type and install
clamp filter (ZCAT 2035-0930A: TDK) at both ends
(camera and video processor ends).
Power over type CameraLink
frame grabber board
CameraLink
frame grabber board
Shield type
C-201KSS
C-501KSS
C-102KSS
1
Advertisement
Table of Contents
