Table of Contents
Advertisement
Functions and operations
Various mode setup and adjustment of KP-F520WCL are performed by the remote control via CameraLink.
Operation and adjustment way of function utilized are described below.
See "Remote control" and "Command list" about communication method of each command.
1. Main functions
(1) TRIGGER : Setting about external trigger
・MODE : Select of mode
OFF (Factory setting）
FIXED SHUTTER
ONE TRIGGER
VD CONTROL
・POLARITY : Select of trigger polarity
POSITIVE (Factory setting) : Input polarity HIGH is made into trigger signal.
NEGATIVE
・SOURCE : Select of trigger source
CL-CC1 (Factory setting) : Input trigger signal from CameraLink signal CC1 (see page 4 "Connector").
12pin
* See "Trigger operation" and "Timing chart".
(2) OUTPUT SIGNAL ： Setting of the tenth pin of DCIN/SYNC connector
OFF (Factory setting)
FLASH OUT
VD OUT
(3) SHUTTER : Setting of electronic shutter
OFF (Factory setting)
1/18, 1/60, 1/100, 1/250,
1/1000, 1/2000,
1/10000, 1/50000 second : Set to setting shutter speed (PRESET shutter).
VARIABLE
-VARIABLE VALUE- : Setting speed of VARIABLE shutter.
10 to 1/100000 second
Shutter speed setting value and exposure time can be derived as follows. (
a) Setting value XYY
X
YY
b) Exposure time obtained from setting value XYY
ShutterSpe
: Trigger mode set to OFF (normal mode).
: Set to Fixed shutter mode.
: Set to ONE trigger mode.
: Set to VD reset mode.
: Input polarity LOW is made into trigger signal.
: Input trigger signal from 7 pin of 12 pin DCIN/SYNC connector.
: No output.
: Output flash pulse (strobe out).
: Output camera VD.
: Shutter operation set to OFF (normal shutter).
: Set to shutter speed from 10 to 1/100000 second (VARIABLE shutter).
: Electronic shutter can be set in the range of 10 to 1/100,000 second in 1536 steps.
obtained from exposure time.
16
int(log(
ShutterSpe
ed
))
1
ShutterSpe
ed
100
int
1
X
1
10
YY
X
16
1
ed
10
(
1
100
16
9
.
16
9
)[
sec]
16
ShutterSpeed
:: μsecond)
5
Advertisement
Table of Contents
