Connector - Hitachi Kokusai Electric KP-F520WCL Operation Manual

Connector

1. CameraLink connector
D.OUT1
Pin No.
1
2
3
4
5
6
7
8
9
10
11
12
13
SDR connector (3M) or equivalent
- The digital out cable should be comprised of a twisted pair of wires having 100Ω characteristic impedance and an outer
heath shield type conductor.
- Connect the shield (ground) of the digital out cable to the ground terminal of the video equipment, frame grabber, etc.
- TX: Transmit data from camera to machine
- RX: Transmit data from machine to camera
(Note) Please do not unplug and insert cable (digital out cable), during the power is supplied to a camera.
(Note) In the CE Marking region, use the shied type and install clamp filter (ZCAT 2035-0930A: TDK)
at both ends (camera and video processor ends).
2. DCIN/SYNC connector
PIN NO.
1
2
3
4
5
6
Connector (camera side)
Plug (matching cable plug)
(Note) Please do not unplug and insert cable (camera cable), during the power is supplied to a camera.
(Note) In the CE Marking region, use the shied type and install clamp filter (ZCAT 2035-0930A: TDK)
at both ends (camera and video processor ends).
Signal
+12V (PoCL)
GND (non-PoCL)
TXOUT 0 (－)
TXOUT 1 (－)
TXOUT 2 (－)
TXCLKOUT (－)
TXOUT 3 (－)
RX (＋) [ SERTC (＋) ]
TX (－) [ SERTFG (－) ]
TRIG-A/VD (－) [ CC1 (－) ]
N.U. [ CC2 (＋) ]
N.U. [ CC3 (－) ]
N.U. [ CC4 (＋) ]
GND
Signal
GND
---- (PoCL)
+12V (non-PoCL)
GND
N.U.
GND
N.U.
: SNH-10-12(RPCB) SAMWOO or equivalent
: HR10A-10P-12S(01) HIROSE or equivalent
Pin No. Signal
14 GND
15 TXOUT 0 (＋)
16 TXOUT 1 (＋)
17 TXOUT 2 (＋)
18 TXCLKOUT (＋)
19 TXOUT 3 (＋)
20 RX (－) [ SERTC (－) ]
21 TX (＋) [ SERTFG (＋) ]
22 TRIG-A/VD (＋) [ CC1 (＋) ]
23 N.U. [ CC2 (－) ]
24 N.U. [ CC3 (＋) ]
25 N.U. [ CC4 (－) ]
+12V (PoCL)
26
GND (non-PoCL)
PIN NO.
7 Trigger IN / VD IN
8
9
10 FLASH OUT / VD OUT
11
12
N.U.: Not used
Signal
GND
N.U.
N.U.
GND
N.U.: Not used
4