Install The Raid Adapter - Lenovo ThinkAgile HX1321 Series User Manual

Figure 31. RAID adapter removal
Step 1. Slide the left-side latch to the unlocked position.
Step 2. Push and hold the right-side latch in the direction as shown.
Step 3. Grasp the RAID adapter by its edges and carefully remove it from the RAID adapter slot on the
system board.
Install a new RAID adapter. See "Install the RAID adapter" on page 65.
If you are instructed to return the old RAID adapter, follow all packaging instructions and use any packaging
materials that are provided.

Install the RAID adapter

Use this information to install the RAID adapter on the system board.
"Read the
installation
Guidelines" on
page 43
Before installing the RAID adapter:
1. Touch the static-protective package that contains the new RAID adapter to any unpainted surface on
the outside of the server. Then, take the new RAID adapter out of the package and place it on a static-
protective surface.
2. If the new RAID adapter is installed with a bracket, remove the bracket.
To install the RAID adapter on the system board, complete the following steps:
"Power off
the server
for this task"
on page 35
Chapter 8
"ATTENTION:
Static Sensitive Device
Ground package before opening"
on page 45
.
Hardware replacement procedures
65