Figure 29. Connecting the cable to RAID adapter
Step 8.
Reinstall the RAID adapter (see "Install a RAID adapter" on page 47 for instructions).
Step 9.
Route the cable in front of DIMM slots by inserting into clip mounted on side of storage cage.
Figure 30. Routing the cable
After you install the interposer card, complete the following steps:
1. For configure the RAID array, see "RAID configuration" on page 65 for instructions.
Install a RAID adapter
Use this information to install a RAID adapter option.
Before you install a RAID adapter, complete the following steps:
1. Read "Installation Guidelines" on page 26 to ensure that you work safely.
2. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with the
bezel pointing toward you.
3. Remove the compute node cover (see "Remove the compute node cover" on page 29 for instructions).
To install the RAID adapter, complete the following steps:
.
Chapter 3
Compute node hardware setup
47