Table of Contents
Advertisement
Using the TC data of the SDI output device
The values of the time code and the users bit to be recorded in the SDI Mode can be selected by setting
[SDI REGEN].
Select the menu.
: [TC/UB SETUP] # [SDI REGEN]
[ON]:
[OFF]:
≥ The following occurs if you select [ON].
j Setups for [TC PRESET] and [UB PRESET] will not be able to change.
j The built-in time code (free run) and users bit will be recorded if it is not possible to receive the TC data due to
mismatched format, no input data, etc.
Recording
USER button
Each of the USER button can register one function from the 29 available functions.
≥ The USER buttons consist of the USER button (USER1) on this unit and 12 USER button icons displayed in the
LCD monitor (USER2 to 13).
Setting the USER button
1
Select the menu.
: [USER SW] # [USER1] to [USER13]
≥ It is not possible to register functions to [USER2] to [USER13] in Playback Mode.
2
Touch the item to register.
≥ For the functions of the USER button that can be registered, refer to page 68.
≥ Touch <INHIBIT> if not registering.
≥ Next (Previous) page can be displayed by touching
3
Touch [EXIT] to complete the setting.
≥ The tables below show the default settings.
USER1 button
USER2 button
USER3 button
≥ <LCD OFF> can only be assigned to [USER1].
≥ <ZOOM W> and <ZOOM T> can be assigned to any buttons from [USER2] to [USER13].
≥ Performing [ALL] in [INITIAL SET] restores these default settings.
Records the value of S-LTC area of the camera recorder connected to the SDI IN
terminal.
Records the built-in time code and users bit.
<LCD REVERSE>
<DISP/MODE CHK>
<FRZ FRAME>
/
.
USER4 button
USER5 button
USER6 to 13 buttons
(l
229)
- 66 -
<SPOTLIGHT>
<MENU>
<INHIBIT>
Advertisement
Table of Contents
