Table of Contents
Advertisement
Network setup screen [Network]
Configure network settings in the Network setup screen.
The Network setup screen consists of the two tabs of [Network] and [Advanced].
≥ It is possible to perform the network setup of the camera head during the CAM Mode.
≥ It is possible to perform the network setup of this unit during the SDI Mode.
∫ Network setup tab [Network]
Click the [Network] tab of the Network setup screen.
This item's setting is reflected when the [Set] button is
pressed.
The following information is required to configure network
settings. Consult your network administrator or Internet
service provider.
≥ IP address
≥ Subnet mask
≥ Default gateway (when using a gateway server or
router)
≥ HTTP port
≥ DNS primary and secondary server addresses (when
using DNS)
¥ IPv4 network
DHCP
Whether the DHCP function is to be used is set by
selecting "On" or "Off" here. Set the DHCP server in such a
way that the same IP address cannot be used by personal computers without the DHCP function or by other network
cameras.
For details on the server settings, consult your network administrator.
Factory settings: Off
IP address(IPv4)
Input the unit's IP address here when the DHCP function is not going to be used. Input an address that will not
duplicate an existing IP address which has been set for a personal computer or another network camera.
Factory settings: 192.168.0.10
≥ Multiple IP addresses cannot be used even when the DHCP function is used. For details on the DHCP server
settings, consult your network administrator.
Subnet mask
Input the unit's subnet mask here if the DHCP function is not going to be used.
Factory settings: 255.255.255.0
Gateway
Input the unit's default gateway if the DHCP function is not going to be used.
Factory settings: 192.168.0.1
≥ Multiple IP addresses cannot be used for the default gateway even when the DHCP function is used. For details on
the DHCP server settings, consult your network administrator.
- 167 -
Advertisement
Table of Contents
