Table of Contents
Advertisement
When the battery is charged, and anyway after at
least 15 minutes' running, the battery charged
hours indicator (Fig.32 Ref.11) will light up and
the electronic control panel will turn off the
generating set.
Setting the switch to the
automatic position after turning the control panel
on sets the generating set in stand-by mode and
does NOT activate the automatic function.
Remember that the time which is taken by
the generating set in automatic mode to
recharge the battery may vary according to
the battery status, the amount of connected
batteries and the season temperature.
Generally, the lower the temperature the less
the time required to charge the battery.
Applying any load higher
than the energy just then available in the
battery will prevent the generating set from
turning on due to insufficient voltage.
7 MAINTENANCE INSTRUCTIONS
Only use original spare
parts. Using poorer quality spare parts may
damage your generating set.
Routine checks and adjustments are of the
essence in preserving a high level of
performance.
Routine
ensures long generating set life.
check or maintenance operation on the
generating set, turn the selector switch (Fig.
31 Ref.2) to the position 1 "manual" in order
to
avoid
accidentally
generating set.
7.1 Service check list
See table at the bottom of page 25.
7.2
Maintenance not requiring specialised
personnel
To perform this kind of service, it will be
necessary to open the generating set door. The
following precautions must therefore be taken:
20
maintenance
also
Before performing any
starting
up
Energy 4010 B
GB
1 The generating set must not be in operation,
and all its parts must be cold
2 Let the generating set cool off.
3
Turn the selector switch to the position "ON"
(manual) (Fig.31 Ref.2)
N.B. Remember to switch the selector switch
to "OFF" (automatic) after completing the
required checks.
7.3 Checking the engine oil level
•
Unscrew the engine oil filler cap and clean the
dipstick (Fig.33 Ref.1).
•
Put the dipstick back in without screwing.
•
Take the dipstick out again, and make sure
that the engine oil level is between the two
(min and max) notches. Should the oil level be
below the minimum notch, restore the oil level
using the recommended type of engine oil
(refer to the engine user and maintenance
manual).
•
Put the dipstick and filler cap back on and
screw tightly.
maximum
level,
malfunctioning of the fuel pump and hence of
the generating set.
the
checking operations must be performed with
the generating set in a perfectly horizontal
position.
Do not fill to exceed the
as
this
could
All
engine
oil
Vers. 001
cause
level
Advertisement
Table of Contents
