Table of Contents
Advertisement
6.2 Turning the generating sets off
To stop the generating set, set the switch 1 to its
"OFF" position (Fig.31 Ref.1).
provided with an internal combustion engine,
therefore, the fuel used is highly flammable.
The exhaust gases are conveyed under the
casing; their temperature, inevitably, is quite
high, even though they are mixed with
cooling air.
Do not touch the casing areas near the
exhaust, and do not put your hands or any
objects inside the casing.
6.3 Information on not recommended uses
must be installed and used by qualified and
authorised personnel only, according to the
manufacturer's
generating sets must only and exclusively be
used to produce electrical power on vehicles
18
The generating set is
These generating sets
instructions.
These
Energy 4010 B
GB
provided with an electrical system built to
standards and according to the quantity of
power delivered.
6.3 Useful tips
To make the best use of the generating sets,
remember that even minor overloads - if they last
long enough - will operate the thermal cut-out
switches (Fig.31 Ref.3).
During the running-in period, do not subject the
new engine to loads exceeding 70% of the rated
load, at least for the first 50 running hours.
6.5 Control and alarm functions (Fig. 30)
2 Display: when the generating set has started
up, the total running hours will be displayed.
Press the key provided below the control panel
display unit (Fig.30 Ref.9) to display the number
of generating set operation hours since the latest
engine oil change.
3 High temperature indicator: this warning light
will light up when the temperature of the
generating set goes over its safety value; the
engine will stop at the same time.
4 Engine oil minimum level indicator: this
warning light will light up to indicate that oil in the
engine has gone below the minimum level. A
safety system will kill the engine automatically to
prevent failures.
5 Engine startup failed: this warning light will
light up to indicate that the generating set has not
started up, after all four start-up attempts.
7 Change oil: this warning light will light up when
the engine has reached 100 running hours since
the latest oil change. Every time the oil is
changed, the After-sales service staff must reset
the timer to zero.
8 Fuel warning: this warning light will light up
when the fuel level inside the extra tank has gone
below its reserve level (about 4 litres)
9 Display time changeover switch: press this
switch to display the running hours since the
latest engine oil change.
10 Reset: When the display shows characters
without any apparent logic, the panel needs to be
reinitialised. Press the Reset key (Fig.30 Ref. 10)
and, holding it down, switch on the panel. When
4 zeroes (0000) are displayed, the panel has
been reinitialised.
6.6 Control panel alarm causes and resetting
During generating set use, alarm signals may be
displayed referring to engine oil checks. After
Vers. 001
Advertisement
Table of Contents
