Advertisement
. " ' -
1.
2.
3.
4.
To replace your battery:
-
Insert a flat object like a dime into the slot on
the
side of
the
transmitter and twist to separate
the halves.
Gently pry the battery out of the transmitter. Do not
use metal flanges to "pop out" the battery.
Put the new battery into the transmitter as shown
on the transmitter. Use a type CR2032 battery,
or equivalent.
Reassemble the transmitter. Make sure the halves are
snapped together tightly so water will not get in.
5.
Check the transmitter operation. If needed, follow
the instructions on resynchronizing your remote
keyless
entry
transmitter.
Resynchronizing Your Remote Keyless
Entry Transmitter
Your remote keyless entry system uses a continually
changing code for increased security. Normally, the
receiver in your vehicle will keep track of this
changing code.
Loss of synchronization will occur if the transmitter
is activated more than 256 times while out of range
of the vehicle.
0
Loss of
synchronization will occur after battery
replacement if the transmitter is immediately
activated more than 16 times while out of range of
the vehicle.
If your remote keyless entry transmitter has stopped work
you may need to resynchronize the transmitter to the vehic
receiver. To do this, press the LOCK and UNLOCK buttons
together and hold for at least seven seconds or
until
the
horn
sounds, when equipped with Content Theft-Deterrent.
Check the remote keyless entry transmitter.
If attempts to resynchronize your transmitter to the
vehicle are not successful, you may need to match the
transmitter
to
the vehicle.
2-11
Advertisement
