Advertisement
f i r n Signal and Lane Change Indicator
The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow you
to signal a turn or a lane change.
To signal
a
turn, move the lever all the way up or
down. When the turn is finished, the lever will
return automatically.
An arrow
on
the instrument
panel will flash in the
direction of the turn or
lane change.
7
I
A
To signal a lane change, just raise or lower the lever
until the arrow starts to flash. Hold it there until you
complete your lane change. The lever will return by
itself when you release it.
As you signal a turn or a lane change, if the arrow
flashes faster than normal, a signal bulb may be burned
out and other drivers won't see your turn signal.
If a bulb is burned out, replace it to help avoid an
accident.
If
the arrows don't
go
on at all when
you
signal
a
turn, check for burned-out bulbs and then check
the fuse (see "Fuses and Circuit Breakers" in the Index
A chime will sound if you leave your turn signal on for
more than 3/4 mile (1.2 km).
Headlamp High/Low Beam Changer
To change your headlamps
from low
beam
to high
beam, or high to low, pull
the multifunction lever all
the way toward you. Then
release it.
When the high beams are on, a light on the instrument
panel also will be on.
Flash-to-Pass Feature
When your headlamps are o f f , pull the lever toward you
to momentarily switch on the high beams (to signal
that
you are going to pass). When you release the lever, they
will turn off.
2-35
Advertisement
