Page 1
User Manual V1.0 Preface Thanks for purchasing Mictrack Asset GPS tracker MT700. This manual shows how to easily program and setup the tracker for the best results. Please read this manual carefully before using this product, so as to avoid delays or confusion with its operation. Please note that specifications and instructions are subject to change without notice to facilitate product improvement.
Mictrack will not be held responsible for any losses caused by using the devices in a wrong scenario or reporting rate. It is highly recommended that users should contact Mictrack before deployment. We are glad to give you the suggestions.
MT700 User Manual V1.0 2. Overview MT700 is an IP68 waterproof asset GPS tracker that uses Cat M1 & NB-IoT technology that can provide super low power consumption up to 8 years standby time powered by internal batteries. Its built-in powerful magnets, easy to install without wiring.
MT700 User Manual V1.0 (most of the NB-IoT network or SIM Card do not support SMS) If choose Cat M1 SIM card, you can setup the unit via following SMS commands (9.1-9.13) or via USB Config cable. Download the USB Config tool from the link: https://bit.ly/MT700-Config-tool...
After connected it will Immediately report a data to the platform; If the device is still in a vibrating state, MT700 will report to server every 60 seconds If there is no vibration for more than 10 minutes, the device will automatically go to sleep .
MT700 User Manual V1.0 For examples:1930000 Reply: Reply: SET LAST VALID GPS ON. 9.8 Low Power alarm When the unit’s internal backup battery is low, it will upload location data to server along with the status “BLP” 9.9 Remove alarm If the device was removed and the light sensor detects the light it will report location data to server along with the status “DEF”...
MT700 User Manual V1.0 10.2 PC login Web: www.trackits.com Choose “ID No.” Input your device’s ID number and password(default is 123456) to login 11. Troubleshooting Issues Caused Solutions 1>The device only reply with Cat M1 sim card and will not reply the...
Page 11
MT700 User Manual V1.0 Please check LED status and Connect network fail. make sure the network connect successful first. GPS platform shows 1.Check the APN setting ; logged off 2. Check IP and port 3. Check network if match GPS platform shows no...
Need help?
Do you have a question about the MT700 and is the answer not in the manual?
Questions and answers