Dualit 72960 Instruction Manual page 10

3.D
Select your target temperature
with the Control Dial.
3.G
Once target temperature is
reached, the Power Base will
beep and stop heating. Note:
Will not beep if muted.
3.J
Always unplug kettle
after each use.
WARNING: After 10 minutes
of no use or input from user, the
lights will turn off but the Power
Base remains energised. Press the
Start/Stop Button once and the
Start/Stop Button will illuminate,
press again and the Screen
will illuminate. ATTENDED
APPLIANCE, UNPLUG
WHEN NOT IN USE: FIRE
RISK.
3.E
Press the Start/Stop Button
to begin heating water.
show on Screen to indicate
heating. CAUTION: WHEN
HEATING, HOT STEAM
WILL BE EMITTED FROM
THE KETTLE. SCALDING
WILL OCCUR IF YOU ARE
WITHIN 400MM OF THE
LID, SPOUT OR STEAM
VENTS EITHER SIDE OF
THE LID.
3.H
If you pressed the Hold Button,
the hold timer will begin
counting down once the target
temperature is reached. The
Power Base will beep 3 times at
the end of the countdown and
stop heating. Note: Will not
beep if muted.
10
3.F
Press the Hold Button if
you want to maintain the
will
temperature for 5 minutes once
the kettle has reached the target
level. The hold timer will appear
on the Screen. Note: You must
press Hold Button before
target temperature is
reached.
3.I
Remove kettle from the Power
Base. To avoid the risk of
splashing, wait 10 seconds after
the cycle has finished, before
pouring slowly. Do not over-tilt
the kettle.