Table of Contents
Advertisement
Your Antenna
Antennas for both AM and FM reception are hidden
in the back glass of your vehicle. There is an
internal antenna module that will switch between
AM and FM, when bands are changed, for
maximum reception performance.
NOTE: Do not attempt to adapt any other type of
antenna system to your audio system.
Using the Controls of Your Cassette
Tape Player
NOTE: Radio power must be on to use the cassette
tape player.
How to insert a tape
Your cassette tape player is equipped with power
loading. Once you insert a tape and push slightly
(with the open edge to the right), the loading
mechanism draws the tape the rest of the way in
40
and play will begin after a momentary tape
tightening process. Display indicates "TAPE" while
tape is playing.
If the player is in the tape mode but not in play,
pressing the "TAPE" button will activate play. If the
"TAPE" button is pressed with no tape inserted, the
display will flash "NO TAPE".
How to locate a desired track on the tape
There are six ways to quickly locate a desired
selection on the tape. You can use the fast forward,
rewind, Blank Skip, "SEEK", "SCAN" or "SIDE 1-2"
functions. Following are brief descriptions of each:
Fast forwarding the tape
To fast forward the tape, press the "FF" button.
The radio will play while the tape is in fast
forward. The light above the "FF" button will blink
while in the fast forward mode. Press "FF" again or
press the "TAPE" button to stop fast forwarding. At
the end of the tape, the direction automatically
reverses and plays the other side of the tape.
Advertisement
Table of Contents
