Table of Contents
Advertisement
Windshield Washer
To clean the windshield, push in the end of the
wiper knob. For a constant spray, keep the knob
pushed in. After you release the knob, the wipers
operate for two to three cycles before turning off (if
the wipers were OFF) or returning to HI, LO, or
the interval setting selected.
If the washer does not work, check the washer
fluid level and fill it if it is low. See the
Maintenance and Care chapter. If there is enough
fluid, consult your nearest Ford or Lincoln-Mercury
dealer.
Do not try to clean the windshield when the
washer fluid container is empty or activate the
washers at any time for more than 15 seconds
continuously. This could damage the washer pump
system.
78
WARNING
Always warm up the windshield with
the defroster before you use the washer
fluid. In freezing weather, the washer
solution may freeze on the windshield
and obscure your vision.
For information about refilling the washer fluid or
replacing your windshield wiper blades, see
Windshield washer fluid and Wipers in the Index.
Hazard Flasher
The hazard flasher serves as a warning to other
drivers to be careful when approaching or passing
your vehicle.
Advertisement
Table of Contents
