How To Tune Radio Stations - Lincoln 1997 Town Car Owner's Manual

How to tune radio stations

There are four ways for you to tune in a particular
station. You can use the "TUNE", "SEEK", "SCAN"
or memory buttons.
Using the "TUNE" function
You can change the frequency up or down one
increment at a time by pressing and releasing either
the left b or right a side of the "TUNE" or
"TUNE DISCS" button. To change frequencies
quickly, press and hold down either the right or left
side of the button.
Manual tuning adjusts your radio to any allowable
broadcast frequency, whether or not a station is
present on that frequency. (See All About Radio
Frequencies in this section.)
36
Using the "SEEK" function
Press the right a side of the "SEEK" button to
select the next listenable station up the frequency
band. Press the left b side of the button to select
the next listenable station down the frequency
band. By holding the button down, listenable
stations can be passed over to reach the desired
station.
Using the "SCAN" function
Pressing the "SCAN" button will begin the scan
mode up the frequency band, stopping on each
listenable station for approximately five seconds.
To stop the scan mode on the presently sampled
station, press the "SCAN" button again.
Setting the station MEMORY PRESET buttons
Your radio is equipped with 6 station memory
buttons. These buttons can be used to select up
to 6 preset AM stations and 12 FM stations (6
in FM1 and 6 in FM2)