Table of Contents
Advertisement
NOTE: Some gate operators and garage door openers
may require you to replace Step 3 with procedures noted
in the "Gate Operator/Canadian Programming" section.
4. Press and hold the just-trained HomeLink button. If
the channel has been trained, the EVIC display will now
state "CHANNEL # TRANSMIT."
If the EVIC display still states "CHANNEL # TRAIN-
ING" repeat Step 3.
NOTE: After training a HomeLink
garage door does not operate with HomeLink and the
garage door opener was manufactured after 1995, the
garage door opener may have rolling code. If so, proceed
to the heading "Programming A Rolling Code System."
5. PROGRAMMING A ROLLING CODE SYSTEM
At the garage door opener motor (in the garage), locate
the "learn" or "training" button.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 133
This can usually be found where the hanging antenna
wire is attached to the garage door opener motor (it is
NOT the button normally used to open and close the
door).
channel, if the
1 — Garage Door Opener
2 — Training Button
3
Advertisement
Chapters
Table of Contents
