Shifting Procedures - Jeep 2010 Commander Owner's Manual

258 STARTING AND OPERATING
additional traction and maximum pulling power for
loose, slippery road surfaces only. Do not exceed 25 mph
(40 km/h).

Shifting Procedures

4WD HI to 4WD LOW
With the vehicle at speeds of 0 to 3 mph (0 to 5 km/h),
key ON or engine running, shift the transmission into
NEUTRAL, and raise the transfer case T-handle. The
"4WD LOW" indicator light in the instrument cluster
will begin to flash and remain on solid when the shift is
complete. Release the T-handle.
NOTE: If shift conditions/interlocks are not met, or a
transfer case motor temperature protection condition
exists, a "CHECK SHIFT PROCEDURES" message will
flash from the Electronic Vehicle Information Center
(EVIC). Refer to "Electronic Vehicle Information Center
(EVIC)" in Section 4 of this manual.
Shifter T-Handle
4WD LOW to 4WD HI
With the vehicle at speeds of 0 to 3 mph (0 to 5 km/h),
key ON or engine running, shift the transmission into
NEUTRAL, and raise the transfer case T-handle. The