Wren Kitchens Vogue WALL UNIT 600 Adjustable Corner Assembly Manual
Hide thumbs
Also See for Vogue WALL UNIT 600 Adjustable Corner:
- Assembly manual (12 pages) ,
- Assembly manual (8 pages) ,
- Assembly manual (8 pages)
Related Manuals for Wren Kitchens Vogue WALL UNIT 600 Adjustable Corner
Summary of Contents for Wren Kitchens Vogue WALL UNIT 600 Adjustable Corner
- Page 1 WALL UNIT 600 Adjustable Corner Assembly Guide For Internal Use: FI.WR.INS.037_WKIN00127_WALL_600_AdjCnr_Rev6.indd...
- Page 2 WALL UNIT 600 Adjustable Corner Assembly Guide BEFORE YOU START INSTALLATION SHOULD BE PERFORMED BY A COMPETENT PERSON ONLY. THIS PRODUCT COULD BE DANGEROUS IF INCORRECTLY INSTALLED Panel A Panel B Panel C Loose Shelf Blanking Panel Frontal x1 Back Panel x2 End Panel x2 Base Panel (packed separately)
- Page 3 Step 1. Step 2. Seat dowel (F) Seat cam dowel (G) into into holes in holes in both end panels (B) Seat (G) Cam Dowel both end panels (B) as shown. into hole as as shown. shown. Step 3. Attach panels x2 (C) to panel (B), using cam dowels (G) (in blue), and also using dowels (F)
- Page 4 WALL UNIT 600 Adjustable Corner Assembly Guide Step 6. Seat dowel (F) Seat (G) Step 7. Cam Dowel into holes in both Seat cam dowel into hole as panels (B) as shown. shown. (G) into holes in both end panels (B) as shown.
- Page 5 Step 10. Ensure unit is square. from top 94mm 126mm Step 11. Slide the back panel clips (T) into the groove of both panels (B) & (C)s. The back panel clips (T) should be evenly spaced as shown and positioned to allow the hanging bracket and corner gussets to be fitted. Onceinplace,tightenscrew. Step 12.
- Page 6 WALL UNIT 600 Adjustable Corner Assembly Guide Care to be taken. Hanging procedure is necessary for a safe installation. Step 13. Hanging Brackets steps a,b & c to be carried out on both sides as shown Detail A Detail A Detail A Step a Step b...
- Page 7 WALL UNITS ONLY Screws for attaching to walls are not provided as these vary depending on materials, thicknessandconstruction.Ensureappropriatefixingsforwallconstructionareused. Step 16. Measure appropriately and attach the 2 x hanging bracket Hanging Bracket plates onto the wall screwing Plate through the provided holes into your wall.
- Page 8 WALL UNIT 600 Adjustable Corner Assembly Guide Adjustable Corner Post Pack Step 19. Attach panel (X) to panel (Y) u singappropriatefixing. Panel X Adapt panels (X) & (Y) where applicable to suit Customer Specific Kitchen Plan. Panel Y Step 20. Attach panels (X) &...
- Page 9 Step 22. Insert hinge in top & bottom holes as shown below. Step 23. Secure hinges by tightening 2 x screws with hinge dowels attached. These are already positioned within the hinges. Step 24. Attach the door to unit where required. Adjust hinges to suit.
- Page 10 WALL UNIT 600 Adjustable Corner Assembly Guide Page 9...
- Page 11 For Internal Use: FI.WR.INS.037_WKIN00127_WALL_600_AdjCnr_Rev6.indd Page 10...